Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: PeteG on December 21, 2019, 04:57:20 AM
-
Hi everyone. I built my own CNC router and I'm using Mach 3 to control it. I haven't done any G Code programming before, so I am likely to be asking a lot of questions, please be patient.
-
Hello and welcome let me know if u need any help . I am a cnc programmer by trade at work I use mastercam just let me know if I can be any help
-
HI Cad Cam Man
Thanks for your kind offer and I have no doubt that I will be contacting you :)
Cheers
Peter
-
Hi everyone. I built my own CNC router and I'm using Mach 3 to control it. I haven't done any G Code programming before, so I am likely to be asking a lot of questions, please be patient.
Hello and welcome ....I was always told the only dumb question is the question not asked
-
If there is anything I can do please dont hesitate