Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: Spragnut on December 19, 2019, 11:12:43 AM

Title: Homing - Reverse Direction?
Post by: Spragnut on December 19, 2019, 11:12:43 AM
Hi,

I've recently set about doing an overhaul/rewire on an old Pacer Cadet router, mechanically it was fine but the electronics were shocking to say the least.

I've set about re-wiring it and also took the opportunity to upgrade to an ESS and MB3 breakout along with some G201X drives, everything is working as it should but I've hit a wall now I'm trying to get the machine to home correctly.

The Cadet is setup to home bottom right as you look at the machine. On the Mach 3 install that came with the machine, which has now died, when incremented from the home position X was positive and Y negative, this worked fine as Fusion can generate gcode to reflect this.

On the Mach 4 install I either get it to increment correctly or home correctly, if I flip the dir pin I get it to increment positively but then the home direction is wrong.

Is there a simple flip home position button that I'm missing, or will I be better off just moving the limit switches so it homes from bottom left?

Any help would be most appreciated.

Cheers
James
Title: Re: Homing - Reverse Direction?
Post by: SwiftyJ on December 19, 2019, 11:36:40 AM
From the top menu go to Configure>Control and then select Homing/SoftLimits. The first column is Home Dir where you can select the homing direction for each axis
Title: Re: Homing - Reverse Direction?
Post by: Spragnut on December 19, 2019, 12:31:31 PM
Thank you!!! Hours I've spent looking for that today and it was right in front of me!!! You've probably just saved me hours tomorrow as well!! Cheers!