Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: captainleeward on November 25, 2019, 02:52:24 PM
-
arrow Keys will not move x and y axis motors from the keyboard. motors do jump when first turned on. using the jog function with the tab does move the x and y axis but only very slowly. no speed control. I have inserted the plug in in the plug in folder. and the other one in the folder
This is a cross fire plasma table using win 7 on a dell laptop computer. Thanks for looking and helping.
no g-code function either.
-
Hi Buddy
Check if you in continuous or step mode? Also check whats the default feed rate?
-
continueuis, can;t find the last one one?