Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Tejas Prajapati on November 25, 2019, 03:36:54 AM
-
Dear Support Team,
I have a NVUM V2 controller. I have moved the stepper motors for all the axis and i am getting 0-10 V DC for spindle speed also. I am at the final stage of my CNC built but stuck at spindle on/off. I have tried all the settings as per NVUM manual but still not working. Please help me to run the spindle from Mach3.
Regards,
Tejas Prajapati
-
Hi Tejas Prajapati,
Unfortunately Novusun is one of the businesses listed in our Hall of Shame for Mach3 Licence violation. As a result this forum does not support assistance with any of it's products unless you are a genuine Mach3 or Mach4 license holder.
This thread referrers; https://www.machsupport.com/forum/index.php?topic=24331.msg238650#msg238650
Tweakie.
(Please contact me by PM if you already have a genuine Mach license).