Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bboaz on November 19, 2019, 10:38:51 AM
-
My Hypertherm 1000 with a Mach 3 controller and an M60 machine torch randomly stops and starts during a cut. Cleaned air filters, new consumables, speed set at 150 ipm for 16 gauge material. I get a red fault light which goes out during the cut and the torch starts cutting again. When I use the hand torch the machine cuts with no problems. I understand that upgrading to a Duromax machine torch for this machine is a desirable upgrade but if something is wrong with the machine a mew machine torch wouldn't solve the problems