Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: Thinder on November 09, 2019, 07:43:54 PM

Title: Tool Change not recognized in MAch4 with new profile
Post by: Thinder on November 09, 2019, 07:43:54 PM
HI all,

 i set up a new machine and moved over all of my macros to a new profile and this setup wont recognize a tool change.  Ive changed the setting to "Tool is tool to use" and checked my macro and its in the file.  It gives no error or anything.  MDI appears to run but the tool selected stays the same.  G43 works properly but i never get a tool number change.  Any ideas?

Thanks,