Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Ariel_Ricardo on October 28, 2019, 08:27:22 AM

Title: Mach3-The machine stop in execut program
Post by: Ariel_Ricardo on October 28, 2019, 08:27:22 AM

hi everyone,

I'm new in this site, and I need help.

I have a machine controlled by mach3.

The operative system is Win7, and used a USB card interface.
(link)

https://www.google.com/imgres?imgurl=https%3A%2F%2Fwww.buildyourcnc.com%2Fimages%2FIMG_20181228_145312__01-800.jpg&imgrefurl=https%3A%2F%2Fbuildyourcnc.com%2Fitem%2FelectronicsAndMotors-electronic-component-breakout-Mach3-USB-Board&docid=2HKAsEYfKSQ2-M&tbnid=b_h_yNX5n8dbDM%3A&vet=10ahUKEwjklvjc9r7lAhVtIrkGHW4ZC9gQMwhGKAIwAg..i&w=800&h=654&client=firefox-b-d&bih=654&biw=1366&q=usb%20mach3&ved=0ahUKEwjklvjc9r7lAhVtIrkGHW4ZC9gQMwhGKAIwAg&iact=mrc&uact=8

I have problem when I run a program, in a "program run mode" in mach3.

The machine normal start to run, but then y stop at 25 second(proximately).

I read in many sites that this problems can be the watch dog(in "general config"), so y see this configiguration, and it is not activated.

Can be any know something about that?

Thanks very much

Ariel

Title: Re: Mach3-The machine stop in execut program
Post by: joeaverage on October 28, 2019, 01:08:25 PM

Hi,
is Mach3 licensed?. In absence of a valid license file it will run in Demo mode for 500 lines of Gcode trhen stop.

Craig

Title: Re: Mach3-The machine stop in execut program
Post by: Ariel_Ricardo on October 28, 2019, 01:18:48 PM

Hi Craig,

Yes, de Mach3 its Licensed.

In fact, I verify the program line stop, and is less than 50.

Ariel

Title: Re: Mach3-The machine stop in execut program
Post by: joeaverage on October 28, 2019, 03:22:11 PM

Hi,
Mach3 lathe Demo line limit is 50 lines, mill limit is 500 lines.

Craig

Title: Re: Mach3-The machine stop in execut program
Post by: Graham Waterworth on October 30, 2019, 08:46:20 PM

If you are using the Licence that came with the board then it will always fail to work.