Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: jevs on September 04, 2019, 09:36:54 AM

Title: Recommendation for precision bore to calibrate probe?
Post by: jevs on September 04, 2019, 09:36:54 AM
I just have a cheap probe right now, but I need something to perform the probe calibration procedure. Does anyone have a recommendation for something to buy?
Title: Re: Recommendation for precision bore to calibrate probe?
Post by: Stuart on September 04, 2019, 10:43:51 AM
Use a ball bearing bearing inner

They are pretty good for size check with your bore gauge/snap gauge to be sure
Title: Re: Recommendation for precision bore to calibrate probe?
Post by: jevs on September 04, 2019, 11:28:02 AM
I decided to buy a 1.0937" Master Setting Ring. It was only $35 shipped.