Machsupport Forum
Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: Alexandre Suk on September 01, 2019, 04:16:33 PM
-
Hello!
Does anyone have a english manual reguarding USB RNR Motion Card, wich uses the driver RNR ECOMOTION V2.0?
The card photo goes attached.
It would be of enourmous help!
-
Hi,
a manual in any language would be a start!
Craig
-
Hi
I know its an old thread but here you can find all the infoon setting up this card
https://buildyourcnc.com/item/electronicsAndMotors-electronic-component-breakout-Mach3-USB-Board
Best reg
Cory