Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: bankshot on September 09, 2007, 10:29:38 PM

Title: wont load
Post by: bankshot on September 09, 2007, 10:29:38 PM

when i try to load from mach3 icon, i get an error message "ITL71.DLL" not found,, i need to recover my g-code programs. re-installing will solve this i assume, but how can i keep those gcode programs intact?

Title: Re: wont load
Post by: Graham Waterworth on September 10, 2007, 03:37:56 AM

Back them up onto another disc or network or memory stick or flash card or floppy or print them out and copy them back in.

Graham.

Title: Re: wont load
Post by: bankshot on September 10, 2007, 11:43:28 PM

thanks for the reply, i have no idea how to back them up when the program wont load, i get the error message when i click the desktop mach3 icon. i have bobcad 21, when i try to access g-codes from mach 3, i dont see anything, im lost

larry

Title: Re: wont load
Post by: Chaoticone on September 11, 2007, 03:24:22 AM

Look in your C:\Mach3\GCode folder. If this is where you save them, you can back them up from here.

Brett