Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: robertspark on August 12, 2019, 07:26:29 AM

Title: Mach4 (4.2.0.4284) Feedrate ??? (wxLathe.set)
Post by: robertspark on August 12, 2019, 07:26:29 AM

Any suggestion why the feedrate for ONE axis at rapid G0 would be higher than the maximum axis velocity set for the motors?

Both motors set at 1200 units / min

units set are mm in config.

MDI
Simple G0 X100 (or Y100) in the simulator

And the feedrate is listed as 1333.33

Title: Re: Mach4 (4.2.0.4284) Feedrate ??? (wxLathe.set)
Post by: robertspark on August 12, 2019, 09:25:14 AM

Seems to work as intended / expected within 4.2.0.4162

G0 X100

Feedrate = 1200 units / min = Axis Maximum Velocity