Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: daniba73 on August 03, 2019, 06:01:43 AM
-
Hello.
would it be possible to change HOLD key behavior in Mach4 ??
I ask this because a soft STOP would be necessary.
the reason for this request is that I lose the synchronism of the axes causing me error in the plugin.
I'm using the LATHE version.
CSMIO IP S. hardware
thank you.
-
Hi,
<feed hold> followed by <stop>.
See this thread:
https://www.machsupport.com/forum/index.php?topic=41547.0 (https://www.machsupport.com/forum/index.php?topic=41547.0)
Craig
-
ok.
I read the discussion.
I put the check mark on the stop when I press pause.
it can suffice me, it does not generate more errors.
thank you!