Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Tarak on September 06, 2007, 10:42:25 PM

Title: When loading program, I've noticed it doesn't display correctly until I REGEN
Post by: Tarak on September 06, 2007, 10:42:25 PM

I think it's only been happening for the last couple of releases.
Anybody else having the same problem?

Title: Re: When loading program, I've noticed it doesn't display correctly until I REGE
Post by: guynamedbathgate on September 09, 2007, 05:58:42 PM

sometimes when I use the editor to, well, edit a code. when I close it sometimes Mach wont display anything at all in the toolpath window. and regen doesnt work either. I can run the program and its fine. but only way to get it to draw a toolpath is to close whole program and relaunch it. Wich means rehoming everything and a big pain in the but to me.
so yes Ive had at least a similar problem.

Title: Re: When loading program, I've noticed it doesn't display correctly until I REGEN
Post by: Brian Barker on September 11, 2007, 10:05:58 PM

we are looking into this at this time... Thanks for the report
Brian