Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: j2mariashop on July 29, 2019, 06:21:33 PM
-
I was sure this topic was posted somewhere but I can't find anything on my specific problem. I've started using Mach 4 after years of my machine running on Mach 3. Now, for some reason, I can't seem to be able to get the feed rate to change on my lathe screen. I've attached my profile. Whether the feed rate is based on rpm or minutes, nothing seems to change the existing feed rate. I looked into the screen edits for the RRO and FRO sliders but can't seem to find anything out of place.
Joe