Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: hille on September 06, 2007, 03:45:26 PM
-
hi everybody,
i have purchased a minitech cnc minimill with mach3 software. after getting everything set up and running i am trying to integrate the mill into my cim system. i would like for it to receive a signal from my plc to execute its program.
any ideas how to go about this?
oh, i do not know anything about modbus.
thanks in advance
hille
-
What is the model and make of your plc and has it got a serial modbus facility?
Whacko