Machsupport Forum
Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: Boots on June 30, 2019, 08:20:56 PM
-
When “Reference all home” the machine moves to Z Home switch, triggers it then does not back off. How can we change the Homing routine to move off the homing switch?? In MAch4 I tried increasing the offset but it does not work.
-
Boots,
Below are my settings as an example.
Regards,
Mauri.
-
Hi Mauri,
Thanks for the reply - my setup is close to your setup; the only difference is the negative value in the soft limits. I will try that.
Thanks, Boots-2b1