Machsupport Forum
Mach Discussion => VB and the development of wizards => Topic started by: newtocnc on September 04, 2007, 11:25:17 PM
-
Hello everyone.
I like to add a button that will multiply the Jog Increment values say by 5,
without effecting the values in the config file.
Is it possible to read the values listed in the config file ( jog increment values)
modify it, and have onother button reset it back to original values.?
Thanks
John
-
Hey dude,
Look under config, then click general, about the middle of the page toward the bottom is the jog increment settings.
ther are 10 of them, leave the 1st 5 what they are, chanage the 2cd five to you *5 amount........
scott
-
If I only want 3 jog increments can I leave the rest blank and will mach skip the blank ones?
-
This would be interesting...
How can i "limit" the increments to 3, for example?
3 increments to cycle through, and then start from the first increment again?
-
If I only want 3 jog increments can I leave the rest blank and will mach skip the blank ones?
I never realized that Drew.
Thanks for the tip. :)
Greg
EDIT: I take that back. I can't get it to work. ;D ;D ;D
-
It was a question not a tip and now I don't remember if it worked. The last few weeks have been a blur. Drew
-
No, Mach will ask you to enter a number.
This is why i asked...
-
Sorry Drew. I misread your post. :)
I guess the only way is to repeat the three values three times. That leaves one odd one (as there is ten spots)
Spartan did you get my PM?
Greg
-
I guess the only way is to repeat the three values three times. That leaves one odd one (as there is ten spots)
This is what i wanted to avoid...
@greg:
yes, I jsut answered and right now i'm sending the screenset (i hope...)
-
I cannot send the zip...?
The ZIP is not accepted by clamAV?
"5.7.1 virus oversized Zip detected by ClamAV"
what the h** is clamAV?