Machsupport Forum

Support => Forum suggestions and report forum problems. => Topic started by: silent tone on September 04, 2007, 11:24:53 PM

Title: Video tutorial link is broken
Post by: silent tone on September 04, 2007, 11:24:53 PM

Links on the navigation bar on most of the Artsoft pages link to http://www.artsoftcontrols.com/artsoft/videos.htm which does have a few videos.  However, I found a link somewhere that I've found much more useful http://www.machsupport.com/videos.htm, and I don't know why the videos are split up like this.  If it's intentional, it is confusing.

Regards,
Tony

Title: Re: Video tutorial link is broken
Post by: scottn on September 22, 2007, 11:28:48 PM

Quote from: silent tone on September 04, 2007, 11:24:53 PM

Links on the navigation bar on most of the Artsoft pages link to http://www.artsoftcontrols.com/artsoft/videos.htm which does have a few videos.  However, I found a link somewhere that I've found much more useful http://www.machsupport.com/videos.htm, and I don't know why the videos are split up like this.  If it's intentional, it is confusing.

Regards,
Tony

Hi Tony,

The machsupport.com/videos.htm link appears to be an outdated page that got left there during the server migration last March.  Most of the video links on there have been consolidated into a new format, found under the large "Click Here" link above the list of remaining videos on the newer page.  I agree with you, though - I like the old format better and find it easier to use...

Thanks,

scott