Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ffulmer on September 04, 2007, 08:39:26 PM
-
I have lost my ability to use my keyboard for jogging, in fact I can’t switch between step and continues or MPG. I can not toggle between Jog and step nor do any of the indictors light up. It worked fine when I calibrated the machine, but since then it stopped working. I had added the spindle and coolant start/stop function so I backed up and remove it and the pin outs but nothing changed. At this time I only have use of the job buttons on the screen in continues mode, which is impossible to move with any precision. Could I have turned something off?
Fred
-
Do you have jog, on/off turned off on the program run screen? Can you jog on that screen?
Brett
-
Brett
Where would you turn it on/off? I checked everywhere and can't find any such command. If I use the tab key the MPG screen comes up and I can move the tables useing the arrows on the MPG screen and I can change the per cent of speed, but other then that nothing else works.
Fred
-
On the program run screen, under tool info. See The screen shot.
Brett
-
Brett
You hit it right on the head. The answer was right in front of me, but for some reason I didn't see it. Thank you.
Fred
-
Your welcome Fred, How do you think I knew that?
::) Because I have done that too, ;D
Brett