Machsupport Forum
Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: franselferink on June 25, 2019, 06:46:27 AM
-
the router accuracy looks like this (see picture). I dont have used cutter compensation. I use a 0.6mm router bit. As far as I know just follow the line (very basic).It turns out dramtically bad.
-
Looks like backslash in X/Y axis
-
Looks like backslash in X/Y axis
I have solved it, it was backslash in the y direction, the coupling to the steppermotor wasnt tight and could move about 1mm