Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: TfGK on June 08, 2019, 03:31:16 PM
-
Help - Mill not starting anymore.
Mach3 will successfully Load G-Code and Cycle Start. G-Code runs in Mach3 with no issue.
However my mill does not respond anymore. I am not sure what has changed.
Everything is powered on and all cables are secure and appear undamaged.
What troubleshooting steps should I consider next?
-
I have noticed under my Ports & Pins in the Input Signals and Output Signals tabs that every has a red X now.
I think this may be why my mill is not receiving output from Mach3.
Trying to figure out now how Input Signals and Output Signals should be reconfigured.