Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Wayne on August 31, 2007, 10:26:41 PM

Title: Demo
Post by: Wayne on August 31, 2007, 10:26:41 PM
Hi
I am ordering my license for Mach3 but haven't got it done yet. When using the demo version I can't get any outputs to light in the diagnostic screen. aka step/ dir  for any axis.  I got my Campbell iso board and have everything hooked up to my Gecko 201s but nothing moves.  DRO axis position works with a program or with jogging.  Also the led on output 4 on the isolation board is supposed to light when Mach 3 is up and running. It does not light.  Is this a disable function on the demo or do I have something setup wrong ?

Mach 3 newbie
Wayne
Title: Re: Demo
Post by: jimpinder on September 01, 2007, 04:05:31 AM
You must have something wrong -

I only use the downloaded version - and everthing is fully functioning.