Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: vco-systems on August 31, 2007, 07:08:17 AM

Title: change spindle speed (eg. laser power) depending on velocity
Post by: vco-systems on August 31, 2007, 07:08:17 AM

I know that its possible to make the "spindle speed" constroll the power of a laser for an laser engraver, but is there any way to make the software compensate for change in velocity when cutting for example corners.

Title: Re: change spindle speed (eg. laser power) depending on velocity
Post by: Brian Barker on September 10, 2007, 12:35:55 PM

That should be under ports and pins Spindle settings... that is what the Lazer option for the spindle should do ...

thanks
Brian