Machsupport Forum

Third party software and hardware support forums. => Promote and discuss your product => Topic started by: Weerasak on April 25, 2019, 07:44:17 AM

Title: MB3, The new ESS breakout board
Post by: Weerasak on April 25, 2019, 07:44:17 AM
The new MB3 is the continued development of the MB series of breakout boards.  It keeps the best features of its predecessors MB1 and MB2 and in addition allows all isolated inputs be used in both NPN or PNP mode and also to operate with either 5V or 24V. In this new design, the ESS board can be directly plugged into the MB3 without using ribbon cables. This makes the ESS easier to install and reduces the distance the signals must travel. It eliminates a number of contact points, as well as inductance and resistance between the ESS and MB3 board.
https://www.cncroom.com/interface-cards/ess-mb3
https://www.cncroom.com/interface-cards/mb3

(https://www.cncroom.com/images/MB3TopPanel5.jpg)  (https://www.cncroom.com/images/ESS-MB3_.jpg)

https://www.youtube.com/v/pGaCyydRLCw