Machsupport Forum
Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: marc1b on April 22, 2019, 08:43:14 PM
-
I am upgrading my Mach 3 (originally installed in 2014) with an Integra to Mach 4 and so far no joy on spindle and axis. I have the limit switches and outputs for coolant, etc working fine. In the diagnostics I do see the motors are enabled when the drives are. But there is no movement.
I have downloaded and installed the latest plugin & firmware (2.03.07)
The current Integra manual shows a 7737 encoder board and I have a 7736. Is this going to work for me? If so what is the mapping as to the drives and encoders?
Thanks!!