Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: manp16 on April 21, 2019, 03:17:29 AM
-
Hi All
I am new to MACH 3, currently using NC Studio on my other CNC Router.
I have the problem of the Jog control operating ALL axis in reverse. At first, I thought it was the keyboard, so I changed the key association, which worked, but when I tried using the Jog Control in Mach 3, it was still reversed. I have tried a few things in the setup, but nothing I do is changing the directions. Please help.
Thanks Andrew
-
Config -> Homing/Limits -> Reversed should help
-
(deleted)
-
Config -> Homing/Limits -> Reversed should help
Thank you for the reply...I have tried this and it didn't seem to work. Do I need to do a reset or something after?
Thanks Andrew
-
Some changes to Mach3 do require a re-start this may be one of them ?
Perhaps try it and see.
-
Please see attached to reverse direction.
(I had deleted my earlier post because I thought TPS's solution would work but it will only work for ref.all home)
-
Thank you. I will try this tomorrow and let you all know how I get on.
Kind Regards
Andrew
-
Please see attached to reverse direction.
(I had deleted my earlier post because I thought TPS's solution would work but it will only work for ref.all home)
This worked..Thank you very much.
-
If it jigs the wrong way, then your axes are setup backwards.
-
Hi All
I am new to MACH 3, currently using NC Studio on my other CNC Router.
I have the problem of the Jog control operating ALL axis in reverse. At first, I thought it was the keyboard, so I changed the key association, which worked, but when I tried using the Jog Control in Mach 3, it was still reversed. I have tried a few things in the setup, but nothing I do is changing the directions. Please help.
Thanks Andrew
I have exactly the same problem. Anyone got a suggestion?
-
Solution is in reply # 5 of this thread