Machsupport Forum
Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: jengineer1 on April 18, 2019, 10:26:26 AM
-
I currently have brushed DC servo motors and drivers (DG4S-08020 DC Servo Drive). I want to use them with the Hicon Integra 6 axis controller. Do I have to purchase the closed loop package?
I am new to this, but it seems like the driver is reading the encoder input and there would be no need to send that information to the controller directly.
-
No, not if you are using step/direction drives that close the loop in the drive.