Machsupport Forum
Tangent Corner => Tangent Corner => Topic started by: Overloaded on April 16, 2019, 02:38:52 PM
-
Hi folks :)
My SuperMAX knee mill is almost ready for new spindle bearings.
It has the Universal Quik-Switch 200 nose but is the same as a Bridgeport regarding the bearings.
I looked around a bit, but am wondering where you more experienced folks would normally go to purchase a set.
New or refurbished ballscrews are next ..... if there's any $$$.$$ left in the kitty. ;D
Thanks for your time,
Russ ... in Eastern WV, USA :)