Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: olf20 on August 14, 2007, 07:56:51 PM
-
Hi all,
I was reading a thread in the bargin basment about the video camera. When I tried to open the video window in Mach3 I get the following error;
Art Code 9991
Is this a function that you have to purchase a special licenses for??
Thanks olf20
-
Nope, it should work OK, but might not work if you dont have a camera connected. I dont have my camera connected at this time but I think the drivers will be there so it just says cant connect to camera, I press ok and the window opens, obviously it just shows a blank screen.
Hood
-
My window will not open at home. I will try the shop computer tomarrow.
Thanks for the reply!!
olf20
-
it should work.... You need to close the video stream when you exit.. other then that you should be good to go.
thanks
Brian