Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: rhtuttle on March 13, 2019, 04:04:23 PM
-
Trying to turn a morse 2 taper using the turn Cycles Taper Cycle. I thought I could just enter .375 for Xi, .5 for Xf and 1.4307 for the angle and it would determine the z Distance. I an't find any combination of buttons, purple square looks right but I get the "IDOD dimensions for X don't match" message.
Anyone know how this is supposed to be done using taper cycles?
Can't find any documentation.
TIA
RT
-
Your Xi should be larger than Xf,
See attached pic
No guarantees :)
This is what I used for trial.
MM
-
Seriously!!?? I looked at that graphic over and over and over and yet missed the Xi and Xf placement. Sorry for being so dense. thanks
RT