Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: gorf23 on March 10, 2019, 06:55:26 PM
-
Pokeys57cnc Homing.
When I home an axis, the home led is set to green but the axis is never set to zero, its always off sometimes only a couple thou but others times a lot..
also doesn't seem to back off.
Also has anyone used pin 17 for pwm spindle, maybe its me but seems backwards to me I connected a volt meter and I get 8.26volts at 0 rpm and 0.016 at 3600 rpm
shouldn't it go up as the rpms increase not down? and thought it was suppose to reach 10v?
Thanks gary
-
Hi,
have a look at the machine Diagnostics page. I suspect you will find that a G92 offset (or possibly a Head or Work
Shift) is in operation. Clear that and your machine cords will be reset as normal.
Craig
-
Nope all is set to zero g92 head and work... but still doesn't zero on home...
did get the spindle working in the correct direction now don't know what I did just started running form 0v to 8.26 as I increase spindle speed..
go figure..
gary
-
any other suggestions?