Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jyamkhan on February 10, 2019, 12:29:19 AM
-
Hi Everyone. I have a fresh installation of Windows 7 Ultimate, 32 bit. The computer has MS Office 360 and Mach3 installed. It runs fine unless I open Mach3. If I open Mach3 it instantly reboots. I read elsewhere that there were compatibility issues with KB4088875; it is not installed. The hot processor/corrupt drive scenarios discussed elsewhere seem unlikely because the system runs fine for days and then reboots if I try to open Mach3. Any suggestions or guidance would be appreciated.
-
hi,
have you read and applied the patch:
https://www.machsupport.com/forum/index.php?topic=38269.0 (https://www.machsupport.com/forum/index.php?topic=38269.0)
Craig
-
Hi Everyone. I have a fresh installation of Windows 7 Ultimate, 32 bit. The computer has MS Office 360 and Mach3 installed. It runs fine unless I open Mach3. If I open Mach3 it instantly reboots. I read elsewhere that there were compatibility issues with KB4088875; it is not installed. The hot processor/corrupt drive scenarios discussed elsewhere seem unlikely because the system runs fine for days and then reboots if I try to open Mach3. Any suggestions or guidance would be appreciated.
my issue has been solved!!!