Machsupport Forum

Mach Discussion => Mach Screens => Topic started by: Tarak on August 13, 2007, 07:50:29 AM

Title: Is it possible to change the MULTIPASS feature to move Y axis each pass instead?
Post by: Tarak on August 13, 2007, 07:50:29 AM

Here's a pic of the feature I mean, it's normally set to Z, but it would be great if I could use the same feature on Y instead.
Thanks.

Title: Re: Is it possible to change the MULTIPASS feature to move Y axis each pass instead?
Post by: poppabear on August 14, 2007, 05:42:48 PM

yea, if you can find where the Multi-pass code lives (subroutine, macro...?), and just change its axis values to Y, but make sure you keep some of the Z stuff like safe z etc.

scott