Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: mariusl on February 07, 2019, 05:27:00 AM

Title: End switch on Db 25 LPT config
Post by: mariusl on February 07, 2019, 05:27:00 AM
Hi
I am using a PoKeys57CNC ver 1.4 to replace the LPT port on an installation. I have the motors turning but cannot seem to get the homing switches active.
I do not use any limit switches but only use homing switches. I cannot find any reference to the "End switch X" that is referred to on the pinout diagram in the manual.
Any ideas on how to do this please?