Machsupport Forum
Third party software and hardware support forums. => Newfangled Solutions Mach3 Wizards => Topic started by: Fred_evans on February 06, 2019, 12:46:51 PM
-
Hello Ron
I am a registered user of Mach3.
Do I need a special liscence for the use of your NFS Turn software? where do i get the liscence and how much does it cost?
regards fred
-
I am trying to run NFS turn - but am getting a message something like
"unliscenced version cant run code"
I am liscenced for Mach3 -but recently a technician reloaded windows etc -
my Mach3 runs OK - just not the NFS turn
What should I do?
beat regards
fred evans
-
https://www.machsupport.com/shop/mach3-addons-for-mill/
:D
-
thanks I will try