Machsupport Forum
Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: lgr on February 05, 2019, 04:22:18 PM
-
I'm considering using this board to control a spindle in place of one unused axis' does the Hicon 7766 output a PWM signal? Thanks
Cnc4Pc C41 - PWM Variable Speed Control Board
https://cnc4pc.com/catalogsearch/result/?q=c41
-
Hello,
The user manual of the C41S describes that it converts a PWM input signal and outputs 0-10VDC.
The HiCON Integra has an onboard 0-10V digital to analog output for controlling a spindle.
-
I'm controlling a second spindle with this board
-
I'm still wondering if this is compatible with the Hicon 7766 to operate a second spindle using an unused axis?
-
It's possible to implement a PWM output on the board but would require some time and development fees.
One of our customers uses the SPINDLE_FW/REV signals that each drive a separate spindle. The spindles will only move in one direction with that setup though.
If you would like custom software or firmware modifications you can email sales@vitalsystem.com with your request.
-
Thanks for the information