Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: stevehuck on February 04, 2019, 05:25:23 PM
-
Hello!
I have a problem with Mach 3. When I click on the icons to start mach mill or mach lathe all i get is a white screen and the computer locks and has to be rebooted. Where do I start to figure out what's going on? I'm running windoze XP with a parallel port setup.
-
I would be inclined to make a secure backup of the Mach3 folder (just in case) then re-install Mach3 over the top of the existing installation (sounds like you have lost or overwritten one of the files Mach requires for it's boot operation).
Tweakie.
-
OK buddy! I'm heading out to the garage with a thumb drive right now. Thanks!
-
Tried to re install but no luck. Then I did an uninstall and a reinstall and that did the trick. Thanks!