Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: wdp67 on January 18, 2019, 12:34:19 PM
-
Hi all
Having trouble getting my spindle to turn off and on via Mach3. It is a nowforever E100 VFD. I have the thing wired to my motion card relay C to C on the vfd and NO to X1 on the vfd. when I change the peramiters on the vfd to run off of Mach3 the spindle comes comes on but when I toggle the spindle toggle or use the m code to shut it off, it just winds down for a few seconds and goes right back to whatever speed was sett on the vfd.
Any idea?
Walt