Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: mpoling on January 17, 2019, 03:28:28 PM
-
Hi everyone,
I have a touchplate and want to corner find from the inside edges rather than the outside. Currently when I go into the settings for Touch, the only option available is Outside with Z. Is there any option available for Inside with Z?
If there isn't, how can I enter the size of the touchplate, as without it, it cannot find the corner properly (or at least it doesn't seem to). The height is there, but width option is not.
Thanks
Mike