Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: nelsonk11 on January 10, 2019, 04:01:56 PM
-
I am looking for someone to collaborate with me on developing a way to use the z axis with a traditional lever (drill press type) switch over from the mpg. Someone who has experience with the mpg and Mach3 would be needed. Contact via email to discuss further
nelsonk11@hotmail.com
-
Sounds to me like you just need to set the spindle lever up as your Z axis. pop a stepper and a belt drive on it and configure Mach3 to run with the MPG you have, and you should be good. With this said I think you'd be better off programming a drilling cycle for what you need doing, it will be more consistent, quicker and safer.
-
I suggest you consider something different. There is too much backlash in the rack and pinion.
Not an answer to your question, but been there done that and similar.
RICH