Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: rellenburg on December 25, 2018, 01:34:59 PM
-
Normally I'm a searcher, but since we can't I need some help. I haven't had the router hooked up in 2 years and my old computer died that I was using on it. I downloaded Mach3 and swapped over the license to new computer and added the UC-100 plugin and drivers. Now when the Mach3 screen boots the reset button is flashing and will not reset. The history shows command stopped due to buffer error. I loaded it on 2 different computers with same result. Any idea what's going on? My specs are in my signature. Thanks, and hope everyone is having a good Christmas.