Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Cav Trooper on December 21, 2018, 06:08:55 PM
-
I am trying to engrave a circle and I get a radius to end of arc differs from radius to startline 677. I have tried redrawing the circle and I'm using Canvas 8 to draw and CamBam to generate the G codes and tool path. Is there a fix in Mach3?
-
Hi,
it may be that your CAM program is producing incompatible arc Gcodes for your Mach3 installation.
Double check the IJ mode is set to incremental on the Config/General Config page per the attached.
Craig
-
Thank you, that was it. It runs great.