Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: MN300 on December 17, 2018, 02:24:54 PM
-
The manual pulse generator mentioned in this website was installed according to the instructions provided.
https://shane.engineer/blog/making-a-generic-pendant-work-with-mach-4
When an axis was selected the carriage immediately moved at whatever jog speed was set. Turning the MPG encoder would add to the speed. The solution was to filter the A and B encoder inputs with a filter value of 1.
The system has an ESS board with a MX4660 on ports 1 and 2, and a C10R10 BOB on port 3 for the MPG
It’s a mystery why those two functions interact. I am adding this post to help anyone who has the same problem and in hopes someone from Artsoft will address it.