Machsupport Forum

Mach Discussion => FAQs => Topic started by: Kees Holland on August 06, 2007, 04:11:08 PM

Title: Mouse doesn't work after closing mach3
Post by: Kees Holland on August 06, 2007, 04:11:08 PM
I use a EPIA MINI ITX board and when I open mach3 it works good
but after  closing mach3 de mouse doesn't work more in WIndows XP
does some body now how to fix this problem.


                                                   best regard,s

                                                         Kees
Title: Re: Mouse doesn't work after closing mach3
Post by: jreggieb on August 07, 2007, 09:47:59 PM
I concur.  Purchased new computer to operate as controller; came loaded with Windows Vista Basic, everything boots up & works fine, but whenever I close Mach 3 or the driver test routine everything ( mouse and keyboard) quit responding.  Set the system up for dual boot with XP as the second OS - same problem under XP.  Tried removing that hard drive & installed another with XP only on it - still the same problem.  Added RAM to a total of 1Gb - same problem (but I can get there faster).  I have 2 other computers (XP OS) which work without problem, however I need these for other applications.   I can't find any differences in the LPT1 settings.  Haven't found the error logs yet & I'm a bit hesitant to dive into the registry for answers.

Any thoughts anybody?