Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dbur525 on November 12, 2018, 03:04:33 PM
-
Hi everyone, i purchased Mach 3 a few years ago and installed it on a windows 7 32 bit desktop with parallel port.
I would like to get a new compute windows 10r and transfer my Mach 3 software over to new computer, how xan i do this conversion without a parallel port? Can i purchase a ethernet smooth stepper and use that?
Thank you to all that respond
-
Hi,
yes an Ethernet SmoothStepper will work well, as would an UC300 or 57CNC. These are US or European made controllers,
I would not recommend any Chinese made ones. I would also recommend buying direct from the manufacturer or their nominated
distributor, there are too many Chinese knock-offs on Ebay and Amazon.
Craig
-
Hi craig
I purchased the smooth stepper from CNC4PC in Florida, its a 3 port small controller box withv5 volt transformer
Thank you for responding to me