Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Olena on October 18, 2018, 06:57:45 PM

Title: Problems with the A-Axi
Post by: Olena on October 18, 2018, 06:57:45 PM

Hi, I'm here because I can not move the A-Axi in Mach3. The Axi is enable but the DRO doesn't move even with commands in MDI. The card that I'm using to controller the Axis is e-cut. The motor work well is for that that I think the problem is the software Mach3 or the controller card.