Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Duael on October 07, 2018, 11:00:41 PM

Title: Fixture Offset Z Value (center of A Head rotation)
Post by: Duael on October 07, 2018, 11:00:41 PM

I have been setting up a new 5 axis machine.
 
Along with determining Tool Length Offset and such, I need to determine the Fixture Offset Z Value for my rotating A Head.
(The Center Point of Rotation for the A Head)
This document explains the procedure clearly.
But I cannot figure out where in Mach3 to enter this date once I obtain the measurements.

Thank you in advance