Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: magnetron on October 04, 2018, 11:10:35 AM
-
hello dear forum,
I want to use this board for paralel port
(https://i.postimg.cc/sBrrtwbs/Mach3_breakout_board.jpg) (https://postimg.cc/sBrrtwbs)
I want to ask if anyone used this board before ?
can I use the limit switch inputs for homeing axes ?
the board is a product of stepperonline
thank you
-
Yes you can use it. Everything works.
-
They work great right up to the point they don't. I went through the 2 I bought. If you use it for basic I/O you should be fine bit I had both of the analog spindle control die within a few days. I bought a motion control board and now everything works like it is supposed.
Buy cheap, buy twice.
Mike