Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: dbur525 on October 03, 2018, 10:15:48 PM

Title: Mach 3 settings for C11G breakout board
Post by: dbur525 on October 03, 2018, 10:15:48 PM

Hi Guys
I have a G0704 mill controlled by 5056 drivers with stepper motors Breakout board was C10 but it failed and i replaced with the C11G
My problem is when i move any of the axis, the motors dont move but the mach 3 screen shows movement in the machine position .
Does anybody know where i can find the mach 3 settings for the C11G breakout board?

Title: Mach 3 settings for C11G breakout board
Post by: truckeic on October 14, 2018, 09:10:06 AM

Quote from: dbur525 on October 03, 2018, 10:15:48 PM

Hi Guys
I have a G0704 mill controlled by 5056 drivers with stepper motors Breakout board was C10 but it failed and i replaced with the C11G
My problem is when i move any of the axis, the motors dont move but the mach 3 screen shows movement in the machine position .
Does anybody know where i can find the mach 3 settings for the C11G breakout board?

Did you ever resolve your problem. Are you doing spindle control as Ivan getting ready to buy a C11 myself


Sent from my XT1635-01 using Tapatalk