Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: adamfromscotland on October 02, 2018, 03:07:41 PM
-
Hi you Guys
Im the new kid in town here
A freshly faced Rookie ready for the banter!
Does anyone know why me mach3 keeps crashing everytime i try to tune me Nema23 motors?
https://www.youtube.com/watch?v=W2bBkjU-R8k (https://www.youtube.com/watch?v=W2bBkjU-R8k)
Using windaes 7 and its a 32 bit! :-*
-
Did you install as administrator and in the default location? Windows can be very picky about this.
Mike
-
Mike
Everything else works ok?
And default location, C Drive MACH3
Tried reinstalling just everytime i click ok it crashes with error
-
When you go to save it has to write to a file. If you didn't install and run as administrator windows may be preventing the file being written and causing a crash. I could be many other things but I usually try the easy ones first.
Mike
-
Thanks Mike for your help, will try this tomorrow its interesting you let me know it was writting to a file! makes more sense now, will let you know how it goes, i was thinking "maybe its to do with my USB Breakout board" as its not a parallel type board!
-
Installed as Admin and ran as Admin still crashes
anyone else have any ideas? ???
-
;D
OMG
I thought MACH3 didnt do windows 10 64 bit?
I swapped PC from windows 7 32 bit to its Big Brother
Windows 10 64 Bit PC
And its working 100%
OH DEAR
I thought they said used Windows 7 32 bit etc etc
I just tuned motors for the first time with my Windows 10 64 bIT PC Using mach 3 and its working 100%
Hope this helps any future users!!!!!